l EOM mdx DIA mdx Internal standard The internal standard is a mixture of all samples. doi:10.1371/journal.pone.0065831.t001 TMT label 127 128 129 130 3006665 126 130 129 128 127 126 129 130 127 20685848 128 126 Proteomics of Affected vs. Spared mdx Muscles Southboro, MA, USA), dried and resuspended in 30 ml 0.1% formic acid. LC-MS/MS Analysis on LTQ-OrbitrapXL. The fractions were analyzed on an LTQ-OrbitrapXL interfaced with an in-house constructed nano-LC column. Twomicroliter sample Vercirnon injections were made with an HTC-PAL autosampler connected to an Agilent 1200 binary pump. The peptides were trapped on a pre-column and separated on a reversed phase column, 20060.05 mm. Both columns were packed inhouse with 3 mm Reprosil-Pur C18-AQ particles. The flow through the analytical column was reduced by a split to approximately 100 nl/min and the gradient was as followed; 0 6 min 0.1% formic acid, 676 min 735% acetonitrile, 0.1% formic acid, 7679 min 4080% acetonitrile 0.1% formic acid. LTQ-OrbitrapXL settings were: spray voltage 1.4 kV, 1 microscan for MS1 scans at 60 000 resolutions, full MS mass range m/z 4002000. The LTQ-Orbitrap XL was operated in a data-dependent mode with one MS1 FTMS scan of precursor ions followed by CID and HCD, MS2 scans of the three most abundant doubly, triply and quadruply protonated ions in each FTMS scan. The settings for the MS2 were as follows: 1 microscans for HCD-MS2 at 7500 resolution, mass range m/z 1002000 with a collision energy of 50%, 1 microscans for CID-MS2 with a collision energy of 30%. Dynamic exclusion of a precursor selected for MS2 was used for 120 s after one repeat, enabling most of the co-eluting precursors to be selected for MS2. Database Search and TMT Quantification. MS raw data files from all 8 SCX fractions per one TMT set and 3 MS runs were merged for relative quantification and identification using Proteome Discoverer version 1.3, respectively. Database search was performed by Mascot search engine using the following critera: Mus musculus in Swissprot protein database from April 2012, MS peptide tolerance as 10 ppm, MS/MS tolerance as 0.5 Da, trypsin digestion allowing 1 missed cleavages with variable modifications; methionine oxidation, cysteine methylthiol, and fixed modifications; N-terminal TMT6-plex label, lysine TMT6-plex label. The detected protein threshold in the software was set to a confidence using the FDR 1% method and identified proteins were grouped by sharing the same sequences to minimize redundancy. For quantification, the ratios of TMT reporter ion intensities in MS/MS spectra from raw data sets were used to calculate fold changes between samples via the relative ratio to the reference pool. Only peptides unique for a given protein were considered for relative quantitation, excluding those common to other isoforms or proteins of the same family. Only peptides with a score.10 and below the Mascot significance threshold filter of p = 0.05 were included. Single peptide identifications required a score equal to or above the Mascot identity threshold. Normalisation on protein median was used. The median of peptides was used for protein ratio and the resulting ratios were then exported into Excel for manual data interpretation. Statistical analysis was performed by Student’s t-test, with p values #0.05, with protein ratios smaller than 21.25 or greater than 1.25 and a coefficient of variation of less than 20% considered significantly different. For correction 
of false-positive values the
