Are determined by three adjustable parameters. In our estimations these parameters have been obtained by fitting the totally free energy curves on the corresponding proton 
transfer measures. Considering that the coordinate in these curves just isn’t the proton coordinate but a 
distinction in between the distances of the bond getting buy LY2109761 broken and formed, the successful mass on the particle getting transferred was set as mH =4, where mH would be the mass with the proton. The energies employed in these estimations have been 1700 cm{1 for step 2 and 1800 cm{1 for step 5. These are approximately the zero point energies of the N-H and O-H bonds. Umbrella sampling calculations The umbrella sampling technique was employed to analyse all the steps involved in the conversion between Galp and Galf within TcUGM. Free energy profiles were computed along different reaction coordinates, conveniently defined for each transformation. Harmonic restraints were applied in order to force the system to wander around the selected values of the reaction coordinate. A restraining force of 350.0 kcal/molA2 was employed in all cases and the reaction coordinate was sampled considering windows of 0.08 A wide. Within each window, an equilibration phase of 65 ps was followed by a production phase of 0.2 ns. The actual values of the reaction coordinate were recorded every 2 fs. Snapshots of the structures were downloaded every 3 ps. The last 30000 data of each window were used to compute the unbiased probability by means of the weighted histogram analysis method . When following each reaction coordinate, the last structure of a given window was used as the starting point for the next one. Simulations of 0.5 ns without any restraint were performed for reactants, products and for each intermediate species in order to check their stability. To check the convergence of the free energy computations, several tests were performed. First, for each step, we compared the free energy profiles obtained using the first half of the data with the second half. Besides, every reaction coordinate was sampled both, forward and backwards. Finally, computations for steps 3 and 4 were repeated three times using different initial configurations. Summing all the steps of the reaction, with their corresponding convergence tests, the total length of the PubMed ID:http://jpet.aspetjournals.org/content/124/1/16 QMMM-MD simulations was 187.5 ns. Below we provide the numerical details of the umbrella sampling calculations for each stage. Stage 1: Formation of the flavin-Galp adduct. This stage consists of just one concerted step in which the bond between Galp and UDP breaks while Galp joins FADH2. Accordingly, the reaction coordinate was defined as z 1 d2 {d1, where d1 is the distance between C1XGAL and N5FADH, while d2 is the distance between C1XGAL and O3BUDP. This coordinate was sampled from 22.03 to 1.89 A. Stage 2: Formation of the iminium ion. This stage was proposed to occur in two consecutive steps. The first one is the tautomerization of FADH- via the transfer of the H atom bonded to N5FADH towards O4FADH. The reaction coordinate for this tautomerization was defined as z 2 d3 {d4, where d3 denotes the N5FADH-H distance while d4 is the O4FADH H distance. Coordinate z 2 was sampled from 21.63 to 1.73 A. purchase 10212-25-6 During the following step, the opening of the ring is initiated by the transfer of the proton linked to O4FADH towards the oxygen atom of the Galp ring, O5XGAL, and proceeds with the breakage of the bond between C1XGAL and O5XGAL. We found that a correct description of this process required a react.Are determined by 3 adjustable parameters. In our estimations these parameters have been obtained by fitting the no cost power curves of your corresponding proton transfer measures. Due to the fact the coordinate in these curves will not be the proton coordinate but a difference amongst the distances with the bond being broken and formed, the helpful mass of your particle getting transferred was set as mH =4, where mH could be the mass in the proton. The energies employed in these estimations had been 1700 cm{1 for step 2 and 1800 cm{1 for step 5. These are approximately the zero point energies of the N-H and O-H bonds. Umbrella sampling calculations The umbrella sampling technique was employed to analyse all the steps involved in the conversion between Galp and Galf within TcUGM. Free energy profiles were computed along different reaction coordinates, conveniently defined for each transformation. Harmonic restraints were applied in order to force the system to wander around the selected values of the reaction coordinate. A restraining force of 350.0 kcal/molA2 was employed in all cases and the reaction coordinate was sampled considering windows of 0.08 A wide. Within each window, an equilibration phase of 65 ps was followed by a production phase of 0.2 ns. The actual values of the reaction coordinate were recorded every 2 fs. Snapshots of the structures were downloaded every 3 ps. The last 30000 data of each window were used to compute the unbiased probability by means of the weighted histogram analysis method . When following each reaction coordinate, the last structure of a given window was used as the starting point for the next one. Simulations of 0.5 ns without any restraint were performed for reactants, products and for each intermediate species in order to check their stability. To check the convergence of the free energy computations, several tests were performed. First, for each step, we compared the free energy profiles obtained using the first half of the data with the second half. Besides, every reaction coordinate was sampled both, forward and backwards. Finally, computations for steps 3 and 4 were repeated three times using different initial configurations. Summing all the steps of the reaction, with their corresponding convergence tests, the total length of the PubMed ID:http://jpet.aspetjournals.org/content/124/1/16 QMMM-MD simulations was 187.5 ns. Below we provide the numerical details of the umbrella sampling calculations for each stage. Stage 1: Formation of the flavin-Galp adduct. This stage consists of just one concerted step in which the bond between Galp and UDP breaks while Galp joins FADH2. Accordingly, the reaction coordinate was defined as z 1 d2 {d1, where d1 is the distance between C1XGAL and N5FADH, while d2 is the distance between C1XGAL and O3BUDP. This coordinate was sampled from 22.03 to 1.89 A. Stage 2: Formation of the iminium ion. This stage was proposed to occur in two consecutive steps. The first one is the tautomerization of FADH- via the transfer of the H atom bonded to N5FADH towards O4FADH. The reaction coordinate for this tautomerization was defined as z 2 d3 {d4, where d3 denotes the N5FADH-H distance while d4 is the O4FADH H distance. Coordinate z 2 was sampled from 21.63 to 1.73 A. During the following step, the opening of the ring is initiated by the transfer of the proton linked to O4FADH towards the oxygen atom of the Galp ring, O5XGAL, and proceeds with the breakage of the bond between C1XGAL and O5XGAL. We found that a correct description of this process required a react.
